High Temperature Corrosion of CoNiCrAlY-Si Alloys in an Air-Na<SUB>2</SUB>SO<SUB>4</SUB>-NaCl Gas Atmosphere
نویسندگان
چکیده
منابع مشابه
High-temperature Corrosion Behavior of Iron Aluminide Alloys and Coatings
A multi-year effort has been focused on optimizing the long-term oxidation performance of ingot-processed (IP) and oxide-dispersion strengthened (ODS) Fe3Al and iron aluminidebased coatings. Based on results from several composition iterations, a Hf-doped alloy (Fe28Al-2Cr-0.05at.%Hf) has been developed with significantly better high temperature oxidation resistance than other iron aluminides. ...
متن کاملNumerical Simulation of High Temperature Corrosion Processes in Mn, Cr, Si, Al – Alloyed Steel Samples
The grain boundary oxidation mechanism in hot rolled steel samples during cooling from 500 °C – 800 °C down to room temperature was mathematically modeled. Given a fixed temperature ramp, the migration of the atomic species (iron, oxygen and the alloying elements) has been calculated with the parabolic rate equation for diffusion. After each small time step, the data was transferred into the da...
متن کاملHigh Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملHigh-temperature Corrosion in Power-generating Systems
Several technologies are being developed to convert coal into clean fuel for use in power generation. From the standpoint of component materials in these technologies, the environments created by coal conversion and their interactions with materials are of interest. Coal is a complex and relatively dirty fuel that contains varying amounts of sulfur and a substantial fraction of noncombustible m...
متن کاملHigh temperature corrosion in practical systems
There is a wide range of engineering systems where either the efficiency, the cost, or the reliability and lifetime is limited by high temperature corrosion processes. This includes gas turbines, boilers of various kinds, coal gasifiers, reformers and catalytic regenerators in the petrochemical industry, and heat exchangers and heat recovery systems of many kinds. The issues can largely be sepa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2011
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.mbw201026