High-temperature annealing and surface photovoltage shifts onSi(111)7×7
نویسندگان
چکیده
منابع مشابه
An investigation on full annealing temperature and annealing twins’ Density in Fe-33Mn-3Si-2Al high-manganese steel
Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...
متن کاملCommunication: enhancement of dopant dependent x-ray photoelectron spectroscopy peak shifts of Si by surface photovoltage.
Binding energies measured by x-ray photoelectron spectroscopy (XPS) are influenced by doping, since electrons are transferred to (p-type) and from (n-type) samples when they are introduced into the spectrometer, or brought into contact with each other (p-n junction). We show that the barely measurable Si2p binding energy difference between moderately doped n- and p-Si samples can be enhanced by...
متن کاملTemperature dependent normal and anomalous electron diffusion in porous TiO2 studied by transient surface photovoltage
A model system of nanoporous TiO2 sensitized with dye molecules at the outer surface is investigated by time resolved surface photovoltage SPV at temperatures between −120 °C and 270 °C to get information about electron diffusion over more than 10 orders of magnitude in time. The SPV transients increase in time due to independent electron diffusion and reach a maximum at a certain peak time due...
متن کاملSurface Morphology Transformation Under High-Temperature Annealing of Ge Layers Deposited on Si(100)
We study the surface morphology and chemical composition of SiGe layers after their formation under high-temperature annealing at 800-1100 °C of 30-150 nm Ge layers deposited on Si(100) at 400-500 °C. It is found that the annealing leads to the appearance of the SiGe layers of two types, i.e., porous and continuous. The continuous layers have a smoothened surface morphology and a high concentra...
متن کاملAnnealing time and temperature
An annealing time of 30-45 seconds is commonly used in PCR reactions. Increase in annealing time up o 2-3 minutes did not appreciably influence the outcome of the PCR reactions. However, as the polymerase has some reduced activity between 45 and 65 C (interval in which most annealing temperature are chosen), longer annealing times may increase the likelihood of unspecific amplification products...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review B
سال: 2008
ISSN: 1098-0121,1550-235X
DOI: 10.1103/physrevb.78.035318