High-Surface-Area Alumina Ceramics with Aligned Macroscopic Pores.
نویسندگان
چکیده
منابع مشابه
Surface Contamination of Alumina Ceramics by Carbon
Article history: Received: 01.05.2016. Received in revised form: 25.07.2016. Accepted: 06.09.2016. This study presents the results of investigating the cause of contamination of aluminum oxide ceramics (Al2O3) in the form of brown colored stain. Contaminated ceramic surfaces were examined with the scanning electron microscope (SEM) equipped with the Energy Dispersive Spectrometer (EDS). The res...
متن کاملProduction of porous Calcium Phosphate (CaP) ceramics with aligned pores using ceramic/camphene-based co-extrusion
BACKGROUND Calcium phosphate (CaP) ceramics are one of the most valuable biomaterials for uses as the bone scaffold owing to their outstanding biocompatability, bioactivity, and biodegradation nature. In particular, these materials with an open porous structure can stimulate bone ingrowth into their 3-dimensionally interconnected pores. However, the creation of pores in bulk materials would ine...
متن کاملPreparation and Characterization of High Specific Surface Area γ-Alumina Nanoparticles Via Sol-Gel Method
In the present investigation, γ-alumina nanoparticles with particle sizes less than 10 nm, high specific surface area (351 m2/g), high pore volumes and relatively narrow pore sizes distribution was prepared via sol-gel method in presence of aluminum isopropoxide as an aluminum precursor, distilled water, acetic acid as hydrolysis rate controller and tert-butanol as solvent. They had meso ...
متن کاملMacroscopic and high-throughput printing of aligned nanostructured polymer semiconductors for MHz large-area electronics
High-mobility semiconducting polymers offer the opportunity to develop flexible and large-area electronics for several applications, including wearable, portable and distributed sensors, monitoring and actuating devices. An enabler of this technology is a scalable printing process achieving uniform electrical performances over large area. As opposed to the deposition of highly crystalline films...
متن کاملMullite-alumina functionally gradient ceramics
Cracks free mullite-alumina Functionally Gradient Ceramics (FGC) have been obtained by sequential slip casting of Mullite-alumina slurries with diserent mullite/alumina ratios. These slurries were prepared with 65 % solids content and viscosities rangingpom 10 to 40 mPa.s. 7he presence of cracks perpendicular to the FGC layers have been attributed to residual stresses developed because of the m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2001
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.109.1276_1035