High strain rate superplastic bulge forming of SiC particle reinforced 2124 aluminum alloy composite.
نویسندگان
چکیده
منابع مشابه
Superplastic hemispherical Bulge Forming of a Ti-Al-Mn Alloy
Superplastic sheet thermoforming has been identified as a standard processing route for the production of complex shapes, especially in the aerospace industry. Ti-Al-Mn (OT4-1) alloy is currently being used for aero engine components as well as other aerospace applications by forming through a conventional route which is typically cost, labour and equipment intensive. The Ti-Al-Mn alloy (made a...
متن کاملSuperplastic Forming of Inconel Alloy 718spf
Superplasticforming (SPF) has become an important manufacturing method for aerospace and fuselage components. The basic reasons for the popularity of this process are reviewed and the compatibilityoffine-grained INCONELB alloy71 8SPF@ to superplasticforming are presented in this paper. The temperature limitations of current aluminum and titanium alloys employed in SPF parts for gas turbine comp...
متن کاملFatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملTowards Superplastic Forming of Az31 Magnesium Alloy with Controlled Microstructure
A recent study on post-superplastic forming properties has shown that heating time prior to testing has a major effect on the post-forming properties of superplastically-formed AZ31 Magnesium alloy sheets. To this point, there has been very little examination into the effects of pre-heating or annealing on superplastic forming. In this work, these effects are examined using AZ31 Mg alloy sample...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1998
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.48.380