منابع مشابه
Optimal Control of Melt Spinning Processes
An optimal control problem for a mathematical model of a melt spinning process is considered. Newtonian and non–Newtonian models are used to describe the rheology of the polymeric material, the fiber is made of. The extrusion velocity of the polymer at the spinneret as well as the velocity and temperature of the quench air serve as control variables. A constrained optimization problem is derive...
متن کاملModification of Nylon 6 , 6 1
Nylon 6, 6 is regarded as tough and ductile materials since it exhibit high tensile elongation to break and high drop weight impact strengths. However, under conditions of stress concentration such as in the presence of sharp notches or cracks, polyamides exhibit brittle failure. This property, evaluated as notched Izod or Charpy impact tests, indicates that unmodified polyamides exhibit relati...
متن کاملMorphology and Melt Rheology of Nylon 11/Clay Nanocomposites
Nylon 11 (PA11)/clay nanocomposites have been prepared by melt-blending, followed by melt-extrusion through a capillary. Transmission electron microscopy shows that the exfoliated clay morphology is dominant for low nanofiller content, while the intercalated one is prevailing for high filler loading. Melt rheological properties of PA11 nanocomposites have been studied in both linear and nonline...
متن کاملHigh-speed label-free detection by spinning-disk micro-interferometry.
Spinning-disk interferometers are a new class of analytic sensors to detect immobilized biomolecules with high speed and high sensitivity. The disks are composed of a large number of surface-normal self-referencing interferometers, analogous to an optical CD, but operating on the principle of microdiffraction quadrature that achieves sensitive linear detection of bound molecules. The surface-no...
متن کاملSimulation of Multifilament Semicrystalline Polymer Fiber Melt-Spinning
The goal of this effort is to provide an accurate simulation of multifilament fiber melt spinning, applicable for a wide range of material and process conditions. For ease of use, the model should run on a standard laptop or desktop computer in reasonable time (one hour or less). Most melt spinning models simulate the formation of a single filament, with little or no attention given to multifil...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sen'i Gakkaishi
سال: 1981
ISSN: 0037-9875,1884-2259
DOI: 10.2115/fiber.37.4_t143