High-power flip-chip mounted photodiode array
نویسندگان
چکیده
منابع مشابه
High-power flip-chip mounted photodiode array.
Four-element modified uni-traveling-carrier (MUTC) photodiode arrays (PDA) flip-chip bonded onto transmission lines on AlN substrates are demonstrated. High RF output powers of 26.2 dBm and 21.0 dBm are achieved at 35 GHz and 48 GHz, respectively, using a PDA with 28-μm diameter photodiodes. A systematic comparison between a PDA with four 20 μm-diameter elements and a discrete detector with the...
متن کاملHigh-power high-linearity flip-chip bonded modified uni-traveling carrier photodiode.
We demonstrate a flip-chip bonded modified uni-traveling carrier (MUTC) photodiode with an RF output power of 0.75 W (28.8 dBm) at 15 GHz and OIP3 as high as 59 dBm. The photodiode has a responsivity of 0.7 A/W, 3-dB bandwidth > 15 GHz, and saturation photocurrent > 180 mA at 11 V reverse bias.
متن کاملA 3-10 GHZ LCR-matched Power Amplifier using Flip-Chip Mounted AlGaN/GaN HEMTs
We report a GaN-based broadband power amplifier using AlGaN/GaN-HEMTs, grown on sapphire substrates, as the active devices. The circuit topology used novel LCRmatching networks in a 4-way binaryWilkinson combiner structure. The devices were flip-chip bonded onto the AlN circuit for thermal management. Using devices with 0.7-pm gate length and 4-mm gate width, a small-signal gain of 7 dB was obt...
متن کاملShot-noise-limited laser power stabilization with a high-power photodiode array.
The output power of a cw Nd:YAG laser was stabilized in a dc-coupled feedback loop with a low-noise multiphotodiode detector and an electro-optic amplitude modulator in the frequency band from 1 Hz to 1 kHz. For the first time, to our knowledge, an independently measured relative power noise of 2.4 x 10(-9) Hz(-1/2) at 10 Hz was achieved, fulfilling the power stability requirements of the Advan...
متن کاملTransfer Molding Encapsulation of Flip Chip Array Packages
Epoxy molding compounds have been developed which can simultaneously underfill and overmold the Flip Chip die in a single transfer molding process. Transfer molding is a well-defined industry process; with suitable mold design, these materials can utilize the currently installed capital base. The ability to apply pressure during the molding process can reduce the void rate under the die as well...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2013
ISSN: 1094-4087
DOI: 10.1364/oe.21.009967