High performance stainless steel-ceramic composite hollow fibres for microfiltration

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High performance ceramic hollow fiber supported PDMS composite pervaporation membrane for bio-butanol recovery

In this work, ceramic hollow fiber supported polydimethylsiloxane (PDMS) composite membranes were developed by dip-coating PDMS layer on the surface of macroporous ceramic hollow fiber support. By controlling the properties of polymer solution and ceramic hollow fiber, high-quality ceramic hollow fiber supported PDMS composite membranes were fabricated for pervaporation (PV) recovery of biobuta...

متن کامل

Performance study of ceramic microfiltration membrane for oily wastewater treatment

Cross-flow microfiltration (MF) processes were studied with oily wastewater using a ceramic ( -Al2O3) membrane with 50 nm pore size. The nfluence of parameters such as transmembrane pressure (TMP), cross-flow velocity (CFV), oil concentration in feed, pH and salt concentration n the separation behaviors were investigated by the measurements of permeate flux, total organic carbon (TOC) removal e...

متن کامل

PEBA/ceramic hollow fiber composite membrane for high-efficiency recovery of bio-butanol via pervaporation

In this work, poly (ether-block-amide) (PEBA)/ceramic hollow fiber (HF) composite membranes with high flux were prepared by dip-coating the ceramic hollow fiber with PEBA polymer solution for pervaporation (PV). The membrane fabrication was optimized by finely tailoring the coating parameters such as the viscosity and concentration of PEBA coating solution, which made the pervaporation flux as ...

متن کامل

Composite rebonding to stainless steel metal using different bonding agents.

The purpose of this study was to determine the in vitro bond strengths of composite rebonded to stainless steel crown metal (SS) using five different bonding agents after composite to SS bond failure had been produced. The adhesive systems were applied to the failed bonds following the manufacturers' instructions and, as a control, composite was bonded to SS without using a bonding agent. Each ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Membrane Science

سال: 2017

ISSN: 0376-7388

DOI: 10.1016/j.memsci.2017.07.017