High Performance Heat Exchanger for Latent Heat Recovery from Flue Gas
نویسندگان
چکیده
منابع مشابه
A Numerical Study on Using Air Cooler Heat Exchanger for Low Grade Energy Recovery from Exhaust Flue Gas in Natural Gas Pressure Reduction Stations
Heat EXchangers (HEX) that are used in City Gate Station (CGS) systems are modeled numerically to recover the exhaust waste heat. It was tried to find the best viscous model to obtain results in accordance with experimental results and to change the heat exchanger design. This HEX is used for recovering heat from exhaust flue gas with a mixture of 40% water and 60% ethylene glycol as the coolin...
متن کاملEnergy Savings Potential through Waste Heat Recovery from Flue Gas for Post Combustion Co2 Capture
Flue gas from a plant using fossil fuels contains CO2. Thus power/process plants using fossil fuels contribute to climate change if CO2 in flue gas is not captured. The process of CO2 capture from flue gas is called „postcombustion‟ CO2 capture. Existing plants may be retrofitted with this process to minimize CO2 emission. Amine solutions are mostly used for this process to scrub the flue gas. ...
متن کاملLatent Heat Recovery in Exhaust Gas of a Condensing Boiler: The Effect of Arrangement of Tubes
Boilers are one of the major energy consumers in the building. For this reason, increasing the efficiency of this device and improving its performance is an effective step in solving the problems in building energy and reducing waste energy. Due to the limited resources of fossil fuels and the increasing cost of energy in the world, manufacturers of these equipment are always working to improve...
متن کاملEnhanced Design of Cross-Flow Microchannel Heat Exchanger Module for High-Performance Aircraft Gas Turbine Engines
Boiling and Two-Phase Flow Laboratory (BTPFL), Purdue University International Electronic Cooling Alliance (PUIECA), Mechanical Engineering Building, 585 Purdue Mall, West Lafayette, IN 47907; Rolls-Royce Purdue University Technology Center (UTC), Maurice Zucrow Laboratories, 500 Allison Road, Purdue University, West Lafayette, IN 47907 Enhanced Design of Cross-Flow Microchannel Heat Exchanger ...
متن کاملIncreasing Cooling Towers Heat Capacity by Flue Gas Introduction
In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2013
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.79.1363