High heat flux limits of the fusion reactor water-cooled first wall
نویسندگان
چکیده
منابع مشابه
The First Fusion Reactor: Iter
28 I n practical terms, the project’s goal is to construct and operate a tokamak experiment which can confine a deuterium-tritium plasma in which the α-particle heating dominates all other forms of plasma heating. Formally, the primary mission of the ITER project is to demonstrate sustainment of a DT plasma producing ~500 MW of fusion power for durations of 300 500 s with a ratio of fusion outp...
متن کاملWater-cooled Heat Load Chopper for High-energy Synchrotron Experiments
FIGURE 2. Traditional X-ray scattering experiment setup. Photo Credit: Argonne National Laboratory. In addition to the setup shown in Figure 2, time resolution at BioCARS is provided by precise synchronization of additional beam blocking equipment placed before the sample under test—two rotating disk choppers and a shutter [2]. The X-ray beam is intercepted by a watercooled heat load chopper wh...
متن کاملOxidation of Ethene in a Wall-cooled Packed- Bed Reactor
Abstract--The selective oxidation of ethene over a silver on cx-alumina catalyst was studied in a pilot plant with a wall-cooled tubular packed bed reactor. Gas and solid temperatures in the catalyst bed were measured at different axial and radial positions as well as concentrations at different axial position. Total pressure, inlet mole fraction ethene, mass flow rate and wall temperature were...
متن کاملDesign Windows for a He Cooled Fusion Reactor*
A design window concept is developed for a He-cooled fusion reactor blanket and divertor design. This concept allows study of a parameter regime under which a possible design exists with different design requirements, such as allowable pumping fraction. The concept identifies not only the required parameter regime, but also investigates the robustness of the design, i.e., the validity of the de...
متن کاملStructured Porous Media for High Heat Flux Fusion Applications
Effective heat transfer is essential for fusion power core components in order to enable the maximum possible power density and power conversion efficiency needed for economic competitiveness and fuel conservation. Helium coolant is particularly attractive for fusion power plant applications due to its inherent safety features. It can be used in conjunction with a refractory metal such as tungs...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Engineering and Technology
سال: 2019
ISSN: 1738-5733
DOI: 10.1016/j.net.2019.03.013