High-Efficiency Stacked Power Amplifier IC With 23% Fractional Bandwidth for Average Power Tracking Application
نویسندگان
چکیده
منابع مشابه
Feedback for High-Bandwidth Power Amplifier Linearization
Current RF power amplifier (PA) linearization techniques are presently being investigated to improve PA linearity and power efficiency. One such linearization technique, Cartesian feedback (CFB), makes use of analog feedback to linearize a nonlinear plant (Figure 1). The commanded baseband symbol, I and Q, are compared to the symbol being transmitted by the PA, the baseband symbol is predistort...
متن کاملInvestigation of Broadband Power Amplifier with High Power-combining Efficiency
A four-device broadband solid-state power amplifier, which is based on radial waveguide power-dividing/combining circuit, has been investigated in this work. The fabricated power amplifier combining four monolithic microwave integrated circuit power amplifiers shows a 12–16.6 dB small-signal gain over a broadband from 6 to 14 GHz. The measured maximum output power at 1 dB compression is 25.6 dB...
متن کاملapplication of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولHigh-Power Inverted Doherty Power Amplifier for Broadband Application
Abstract This paper presents a high-power inverted Doherty power amplifier for broader operational bandwidth. After analyzing two operation modes according to the load modulation of the Doherty power amplifier, the inverted Doherty structure was selected. In the design, the load impedances for optimum broadband characteristics at both the back-off and peak power levels. The Doherty power amplif...
متن کاملPower Efficiency Improvements through Peak-to-Average Power Ratio Reduction and Power Amplifier Linearization
Many modern communication signal formats, such as orthogonal frequency-division multiplexing (OFDM) and code-division multiple access (CDMA), have high peak-to-average power ratios (PARs). A signal with a high PAR not only is vulnerable in the presence of nonlinear components such as power amplifiers (PAs), but also leads to low transmission power efficiency. Selected mapping (SLM) and clipping...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2019
ISSN: 2169-3536
DOI: 10.1109/access.2019.2957608