High-Density Optical Backplane Using Small Diameter Optical Fiber
نویسندگان
چکیده
منابع مشابه
Characteristics of Angora rabbit fiber using optical fiber diameter analyzer.
An experiment was conducted to describe the characteristics of Angora rabbit fiber using optical fiber diameter analyzer (OFDA). A total of 349 fleece samples were collected from 60 French Angora rabbits. Recorded measurements of OFDA were as follows: mean fiber diameter, CV of fiber diameter, comfort factor, spinning fineness, mean fiber curvature, SD of fiber curvature, mean opacity of fibers...
متن کاملPolymer optical waveguide based bi-directional optical bus architecture for high speed optical backplane
With the technology trend of using optical interconnects as an alternative to traditional copper interconnects, basic elements such as waveguides and waveguide bus structure are studied worldwide. A novel 3-node bi-directional 50μm optical waveguide bus architecture with embedded mirrors is proposed and fabricated on flexible substrate. The fabrication is achieved by lithography-free molding. D...
متن کاملOptical Fiber for High-Power Optical Communication
We examined optical fibers suitable for avoiding such problems as the fiber fuse phenomenon and failures at bends with a high power input. We found that the threshold power for fiber fuse propagation in photonic crystal fiber (PCF) and hole-assisted fiber (HAF) can exceed 18 W, which is more than 10 times that in conventional single-mode fiber (SMF). We considered this high threshold power in P...
متن کاملWeight Measurements by Using Simple Optical-Fiber Sensors (RESEARCH NOTE)
The use of different optical-fiber sensors for weighing measurements is Abstract described. By using three different mechanical stressing mechanisms, the operation of the fiber-to-fiber transducer systems are tested and the results are presented. Parameters such as sensitivity, hysteresis, resolution, and dynamic range are measured. A comparison of the results has shown that the sensor system m...
متن کاملPhotolithography-free polymer optical waveguide arrays for optical backplane bus.
In this paper, an innovative 3-to-3 bi-directional optical bus architecture based on multimode polymer waveguides with embedded 45° micro-mirrors was successfully demonstrated. With a lithography-free imprinting process by high quality electroplated metallic mold, the device can be precisely replicated with a low fabrication cost. Superior to any point-to-point optical waveguide, the implemente...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Electronics Packaging
سال: 2006
ISSN: 1343-9677,1884-121X
DOI: 10.5104/jiep.9.289