High counting rate, two-dimensional position sensitive timing RPC
نویسندگان
چکیده
منابع مشابه
Front-end electronics for high rate, position sensitive neutron detectors
Advanced neutron detectors for experiments at new spallation sources will require greater counting rate capabilities than previously attainable. This necessitates careful design of both detector and readout electronics. As part of a new instrument for protein crystallography at LANSCE, we are constructing a detector whose concept was described previously (IEEE Trans. Nucl. Sci. NS-46 (1999) 191...
متن کاملA Large-Area Timing RPC
A large-area Resistive Plate Chamber (RPC) with a total active surface of 160×10 cm was built and tested. The surface was segmented into two 5-cm wide strips readout on both ends with customized, very high speed, front-end electronics. A timing resolution σ = 50-75 ps, with an efficiency for Minimum Ionizing Particles (MIPs) larger than 95%, was attained over the whole active area, in addition ...
متن کاملHigh granularity, symmetric differential readout - timing multigap RPC
In this contribution we report the results of R&D activity concentrated on the development of a multigap RPC prototype with strip readout for high counting rate and high multiplicity environment as it is required by the low polarangle region of CBM-TOF detector. In order to cope with the strong counting rate requirements of the inner part of the CBM-TOF wall (∼ 2x10 part.·cm−2·s−1 ), we built f...
متن کاملA model for RPC detectors operating at high rate
We present a simple model to describe the behavior of Resistive Plate Chambers (RPC) exposed to a high particle flux. We show that the RPC current, I ; saturates at large flux values and we explain why the dependence of I on the applied voltage V0 is essentially linear. We show that in the saturated regime the current is controlled by the value of the bulk electrode resitivity, r; which is dire...
متن کاملJoint Recovery of Timing and Position Information in Two-Dimensional Magnetic Recording (TDMR)
In two-dimensional magnetic recording (TDMR), bit sizes are expected to be comparable to grain sizes in order to achieve very high areal-densities. As a consequence, the channel suffers from not only severe two-dimensional (2D) interference but also from cross-track bit location errors (known as position errors) and down-track bit location errors (known as timing errors). These position and tim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Instrumentation
سال: 2012
ISSN: 1748-0221
DOI: 10.1088/1748-0221/7/11/p11003