H−formation process in a multicusp ion source
نویسندگان
چکیده
منابع مشابه
Multicusp Ion Source for Induction Linac Applications
At LBNL we are investigating the use of gaseous ion sources for induction linac applications such as heavy ion inertial fusion. Typical requirements for the ion source is to produce 20 μs pulses with a rise-time of 2 μs. The current density should be greater than 100 mA/cm2 at a duty cycle of 10 Hz [1]. Noble gases such as krypton, neon and xenon will be used. The source used for the measuremen...
متن کاملApplication of a Pulsed , RF - driven ) Multicusp Source for Low Energy Plasma Immersion Ion Implantation
The multicusp ion source has the capability of producing large volumes of uniform, quiescent, high density plasmas. Due to the versatility of the multicusp source, a plasma chamber suited for plasma immersion ion implantation (PIII) was readily constructed. Conventional PIII pulses the bias voltage applied to the substrate which is immersed in a CW mode plasma. However, in the interest of findi...
متن کاملNumerical simulation for optimization of multipole permanent magnets of multicusp ion source
A new ion source will be designed and manufactured for the CYCLONE30 commercial cyclotron with a much advanced performance compared with the previous one. The newly designed ion source has more plasma density, which is designed to deliver an H beam at 30 keV. In this paper numerical simulation of the magnetic flux density from permanent magnet used for a multicusp ion source, plasma confinement...
متن کاملMulticusp ion source with external RF antenna for production of H− ions
A multicusp ion source with modular design was developed at LBNL for production of H− ions. The source consists of a front plate, two multicusp front chambers, a quartz flange with external 3-loop RF antenna and a rear multicusp chamber. The source has LaB6 sputtering target at the rear chamber to lower the work function of the surfaces by coating them with LaB6 and an external cesium oven on t...
متن کاملDEVELOPMENT OF A 15 rnA DC H- MULTICUSP SOURCE FOR CYCLOTRON
A 15 rnA DC Hmulticu9p source ha5 been developed for TRJO cyclotrons. ThI.s source Is abo used for a 900kV tandem accelerator to obtain 10 rnA protons at 1.8 MeV. The starting point ofthl.s development program wu the 5-7 rnA DC Hcusp source developed at TRIUMF during 1987-1990 period. Major elTorts Included the !earch for the optimal filament materiab, shape and location; comparison of cusp Une...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Letters
سال: 1987
ISSN: 0031-9007
DOI: 10.1103/physrevlett.59.787