HF Multiresonant Electronic Ballast for Fluorescent Lamps With Constant Filament Preheat Voltage
نویسندگان
چکیده
منابع مشابه
An Electronic Ballast for Fluorescent Lamps with No Series Passive Elements
∗ Corresponding author Abstract -This exploratory study examined the possibility of driving a fluorescent lamp at high frequency with no serially connected passive elements. The proposed driver is a full bridge stage controlled by the phase shifted PWM scheme. Current feedback was used to stabilize the average of the rectified lamp current to a set value. The experimental results of this resear...
متن کاملDesign and Implementation of Uninterruptible Power Supplies for Fluorescent Lamps with Electronic Ballast
This paper is concerned with the design and implementation of high performance uninterruptible power supplies (UPS) for fluorescent lamps with electronic ballast. The UPS design is based on the capacity and voltage ratings of the lighting equipment. The current-predicted control technique is used to control the half-bridge switch-mode rectifier so as to improve the power factor and reduce the c...
متن کاملA Dimmable High Power Factor Electronic Ballast for Compact Fluorescent Lamps
........................................................................................................................................... ii Acknowledgements .......................................................................................................................... v Chapter
متن کاملHigh-Frequency Dimmable Electronic Ballast for Automotive HID Lamps
This paper presents a high-frequency electronic ballast for HID lamps. A new fixed frequency dimming method with low EMI features is developed in this research. The proposed electronic ballast has the advantages of high power density, simple circuit and low EMI features. The circuit operating principle and design procedures are described in detail. A laboratory prototype was built and tested. T...
متن کاملA MHz Electronic Ballast for Automotive-Type HID Lamps
The compatibility of the Current Sourcing Push Pull Resonant Inverter (CS-PPRI) with the driving requirements of HID lamps designated for automotive headlight applications was investigated theoretically, by simulation and experimentally. The study reveals that a based ballast (CS-PPRI) complies with the automotive requirement of very fast warm up. The experimental ballast was run under Zero Vol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Industry Applications
سال: 2008
ISSN: 0093-9994
DOI: 10.1109/tia.2007.912740