HEAVY-OIL PRODUCTION USING EMULSION FLOODING
نویسندگان
چکیده
منابع مشابه
Optimized polymer enhanced foam flooding for ordinary heavy oil reservoir after cross-linked polymer flooding
A successful cross-linked polymer flooding has been implemented in JD reservoir, an ordinary heavy oil reservoir with high permeability zones. For all that, there are still significant volumes of continuous oil remaining in place, which can not be easily extracted due to stronger vertical heterogeneity. Considering selective plugging feature, polymer enhanced foam (PEF) flooding was taken as fo...
متن کاملOptimal Well Placement Improves Heavy Oil Production
Compared to vertical or lowinclination wells, horizontal wells can deliver higher production rates, higher recovery factors, and more efficient use of steam in thermally enhanced recovery projects for heavy oil. However, the shallow, thin, and friable sand reservoirs in Columbia’s Girasol field present several challenges to the accurate placement of horizontal wells. Schlumberger was contracted...
متن کاملA Study on the Mechanism of Urea-assisted Steam Flooding in Heavy Oil Reservoirs
The Biqian-10 block, located in Henan Oilfield of Sinopic, contains many thin and interbedded reservoirs, which have been operated by cyclic steam stimulation for 20 years or more. Therefore, it is a challenge to implement the conventional steam flooding. In order to improve the recovery of steam flooding, urea was used to assist steam flooding. Urea can decompose into CO2 and NH3, which are be...
متن کاملModeling Water-in-Oil Emulsion Formation Using Fuzzy Logic
Yildiz Technical University, Faculty of Civil Engineering, Department of Environmental Engineering, 34220 Davutpasa, Esenler, Istanbul, Turkey Tel.: +90 212 383 5376, Fax: +90 212 383 5358 E-mail: [email protected]; [email protected] Spill Science, 1717 Rutherford Point, S.W. Edmonton, Alberta, Canada T6W 1J6 Tel.: 780 989 6059, Fax: 780 433 6444 E-mail: [email protected] (Merv Finga...
متن کاملMasters Thesis: Oil-Reservoir Flooding Optimization using the Simultaneous Method
Today, oil recovery is often based on reactive control using water flooding. Water is injected to push the oil towards the producing wells until water is being produced, which requires a shutdown of the producing well. This form of production may not yield more than 35% of the oil initially present. A better strategy exists which is based on closed-loop reservoir management (CLRM). CLRM uses a ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nigerian Journal of Technology
سال: 2016
ISSN: 2467-8821,0331-8443
DOI: 10.4314/njt.v35i2.18