Heat Treatment of Corrosion Resistant Steel for Water Propellers Fabricated by Direct Laser Deposition
نویسندگان
چکیده
منابع مشابه
DETERIORATION OF PITTING CORROSION OF 316 STAINLESS STEEL BY SENSITIZATION HEAT TREATMENT
In this research pitting Corrosion of a sensitized 316 stainless steel was investigated employing potentiodynamic, potentiostatic techniques. Sensitization process was carried out on as-received alloy by submitting the specimen in electric furnace set at 650°Cfor five hours and then the specimen was quenched 25°C water. Potentiodynamic polarization of as received and sensitized specimens in 1M ...
متن کاملEvaluation of Corrosion-Resistant Steel Reinforcement
The corrosion of steel reinforcement in an aging highway infrastructure is a major problem currently facing the transportation engineering community, in particular bridge engineers. In the United States, maintenance and replacement costs are measured in billions of dollars. Further, the use of deicing salts has resulted in steady deterioration of bridge decks due to corrosion. These concerns ha...
متن کاملStructural Characterization of Highly Corrosion-resistant Steel
Structural features of novel corrosion-resistant LC 200N steel were investigated. Mössbauer spectrometry was chosen as a principal method of investigation. Surface as well as bulk properties were studied using Conversion Electron Mössbauer Spectrometry and transmission technique, respectively. Complex behaviour of magnetic and non-magnetic phases was identified in the samples by these two techn...
متن کاملInvestigating the microstructure and hardness of 17-4PH steel and Stellite cladded by direct laser deposition process on 17-4PH steel substrate
The purpose of this research is to laser cladding of stellite6 and stainless steel 17-4PH powders on the substrate of stainless steel 17-4PH, and investigate its solidification microstructure. The results showed that the microstructure of the stellite6 cladding has a cobalt solid solution ground phase with an FCC structure and Cr7C3 and Cr23C6 carbides. Also, the values of the primary dendrit...
متن کاملInvestigating the microstructure and hardness of 17-4PH steel and Stellite cladded by direct laser deposition process on 17-4PH steel substrate
The purpose of this research is to laser cladding of stellite6 and stainless steel 17-4PH powders on the substrate of stainless steel 17-4PH, and investigate its solidification microstructure. The results showed that the microstructure of the stellite6 cladding has a cobalt solid solution ground phase with an FCC structure and Cr7C3 and Cr23C6 carbides. Also, the values of the primary dendrit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13122738