Heat transfer, erosion and acid condensation characteristics for novel H-type finned oval tube
نویسندگان
چکیده
منابع مشابه
Characteristics of forced convection heat transfer in vertical internally finned tube
This work presents a numerical investigation of a vertical internally finned tube subjected to forced convection heat transfer. The governing equations were solved numerically using the control volume technique. Nusselt number, Nu, and friction factor multiplied by Reynolds number, fRe, are influenced greatly by the height and number of the radial fins. The velocity and temperature distribution...
متن کاملFriction Loss and Heat Transfer Coefficient in Finned Tube Heat Exchangers for Reheating Massecuites
Equations developed for packed columns may be used to predict the overall heat transfer coefficient and friction loss in massecuite reheaters. The results seem to indicate that exchangers with the tubes staggered give higher heat transfer rates than those with the tubes in line.
متن کاملHeat Transfer from Finned Surfaces
conv hAs (Ts T ) where As is the heat transfer surface area and h is the convection heat transfer coefficient. When the temperatures Ts and T are fixed by design considerations, as is often the case, there are two ways to increase the rate of heat transfer: to increase the convection heat transfer coefficient h or to increase the surface area As. Increasing h may require the installation of a p...
متن کاملExperimental Investigation of Heat Transfer Effectiveness on Finned - Tube Thermoacoustic Heat Exchanger
Heat exchangers are some of the most important parts in thermoacoustic devices. In an oscillatory flow condition, the flow and temperature fields around the heat exchangers can be quite complex and it may significantly affect their heat transfer behaviour. As a result, one cannot directly apply the heat transfer correlations for a steady flow to the design of heat exchangers operating in oscill...
متن کاملEffective Heat Transfer Enhancement in Finned Tube Heat Exchanger with Different Fin Profiles
During cross flow in a heat exchanger, heat transfer in the front portion of the tube is more compared to back portion of the tube. This is due to less formation of vortices at the backside of the tube. For uniform heat transfer to take place throughout the tube, it is necessary to increase the vortex formation at the rear side of the tube. The aim of this study is to explore the possibilities ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2015
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/88/1/012030