Heat Transfer and Pressure Drop for Refrigerant R-12 Evaporating in a Horizontal Tube

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A numerical investigation of γ-Al2O3-water nanofluids heat transfer and pressure drop in a shell and tube heat exchanger

The effect of γ-Al2O3 nanoparticles on heat transfer rate, baffle spacing and pressure drop in the shell side of small shell and tube heat exchangers was investigated numerically under turbulent regime. γ-Al2O3-water nanofluids and pure water were used in the shell side and the tube side of heat exchangers, respectively. Since the properties of γ-Al2O3-water nanofluids were variable, they were ...

متن کامل

Flow Boiling Heat Transfer and Pressure Drop of R1234ze(E) and R32 in a Horizontal Micro-Fin Tube

In the present study, the flow boiling heat transfer of R1234ze(E), R32 and zeotropic mixture R1234ze(E)/R32 (50/50 mass%) in a horizontal micro-fin tube is experimentally investigated to clarify the pressure drop and heat transfer characteristics. Tested micro-fin tube is made of copper, and its geometry is as follows, 6.00 mm in outer diameter, 5.21 mm in mean inside diameter, 0.26 mm in fin ...

متن کامل

Experimental Investigation on Evaporation Heat Transfer and Pressure Drop Characteristics of HFC-161 in a Horizontal Smooth Tube

The evaporation heat transfer and pressure drop characteristics of HFC-161 in a horizontal smooth tube with an inside diameter of 9 mm was experimentally investigated. The local heat transfer coefficient and total pressure drop were measured at the heat flux ranging from 15 – 25 kW/m, the mass flux ranging from 100 – 200 kg/(m·s), and the evaporation temperature of 5, 10 °C. The experimental re...

متن کامل

Turbulent Heat Transfer and Pressure Drop for

Abstract. The purpose of this paper is to solve a two point boundary value problem (TPBVP) using Multiple Shooting Method. A production model used is a finished good warehouse to store products which are manufactured but not immediately consumed. Once a product is made and put into inventory it incurs the holding costs of two kinds: physically storing and insuring, and the carrying charges of h...

متن کامل

Turbulent Heat Transfer and Pressure Drop for

The main objective of this paper is to propose a new friction compensation mechanism applied to robotic actuators. Friction is a phenomenon that changes with time and with actuator’s operational conditions. To deal with these parameters variations, it is proposed a neuro-fuzzy algorithm for friction identification and compensation. A Neural Network (NN) was trained off line. The NN output (comp...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Chemical engineering

سال: 1974

ISSN: 0375-9253

DOI: 10.1252/kakoronbunshu1953.38.884