Heat transfer and pressure drop during condensation of refrigerant 134a in an axially grooved tube
نویسندگان
چکیده
منابع مشابه
A numerical investigation of γ-Al2O3-water nanofluids heat transfer and pressure drop in a shell and tube heat exchanger
The effect of γ-Al2O3 nanoparticles on heat transfer rate, baffle spacing and pressure drop in the shell side of small shell and tube heat exchangers was investigated numerically under turbulent regime. γ-Al2O3-water nanofluids and pure water were used in the shell side and the tube side of heat exchangers, respectively. Since the properties of γ-Al2O3-water nanofluids were variable, they were ...
متن کاملHeat Transfer and Pressure Drop During HC-600a (Isobutane) Condensation Inside a Brazed Plate Heat Exchanger
This paper presents the heat transfer coefficients and the pressure drop measured during HC-600a (Isobutane) condensation inside a brazed plate heat exchanger: the effects of saturation temperature, refrigerant mass flux and vapour super-heating are investigated. The heat transfer coefficients show weak sensitivity to saturation temperature and great sensitivity to refrigerant mass flux. At low...
متن کاملIn Tube Evaporation Heat Transfer of Refrigerant Mixtures
Heat transfer coefficient data was taken during in-tube evaporation of five differenct refrigerant mixtures. These measurements were performed in a 318" O.D. (9.7 mm) smooth copper tube at refrigerant temperatures of -zoe and 4°C. Four different mass fluxes ranging from 125 to 375 kg/s-m2 were tested. On a mass basis, the five different mixtures tested were: R-125 (40%) I R-32 (60%), R-32 (30%)...
متن کاملAn Experimental Comparison of Evaporation and Condensation Heat Transfer Coefficients for HFC-134a and CFC-12
Evaporation of HFC134a inside smooth, horizontal tubes is studied. Te,;ts are made with pure refngerant and with oil-refrigerant mixtures. Heat flux has varied from 2 kW/n? to 10 kW/m . The inner diameter of the tubes are 12 mm. T1.1o evaporators are used, 4 and 10 m long. Oil content is varied from 0 to 2.5 mass percentage (synthetic oil, EXP-0275). Oil free HFC134a is found to have higher hea...
متن کاملExperimental Study On R-134A Condensation Heat Transfer Characteristics In Plate And Shell Heat Exchangers
In this study, condensation heat transfer experiments were conducted with two types of plate and shell heat exchangers (P&SHE) using R-134A. An experimental refrigerant loop has been established to measure the condensation heat transfer coefficient of R-134A in a vertical P&SHE. Two vertical counter flow channels were formed in the P&SHE by stacking three plates of geometry with a corrugated tr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Heat and Mass Transfer
سال: 1999
ISSN: 0017-9310
DOI: 10.1016/s0017-9310(98)00307-x