HEAT REJECTION AVOIDANCE IN COMBUSTION ENGINES

Heat Transfer in Internal Combustion Engines

A heat transfer model has been developed that uses quasi-steady heat flux relations to calculate the heat transfer from combustion gases through the cylinder wall to the coolant in an internal combustion engine. The treatment of convective heat transfer accounts for the physical problems of rotating and impinging axial flow inside the engine cylinder. The radiative heat transfer includes gas ra...

Modeling of Heat Losses Within Combustion Chamber of Diesel Engines

The cylinder working fluid mean temperature, rate of heat fluxes to combustion chamber and temperature distribution on combustion chamber surface will be calculated in this research. By simulating thermodynamic cycle of engine, temperature distribution of combustion chamber will be calculated by the Crank-Nicolson method. An implicit finite difference method was used in this code. Special treat...

Is Thermal Barrier Coating for Low Heat Rejection in SI Engines or Diesel Engines?

The diesel / gasoline engine rejects about two thirds of the heat energy of the fuel, one-third to the coolant, and one third to the exhaust, leaving only about one-third as useful power output. Theoretically if the heat rejected could be reduced, then the thermal efficiency would be improved, at least up to the limit set by the second law of thermodynamics. Low Heat Rejection (LHR) engines aim...

Internal Combustion Engines

Transient combustion control of internal combustion engines

This thesis addresses the problem of combustion control for automotive engines. A method is proposed to complement existing controllers, which use lookup tables based on steady-state operation. During transients, the new control method adjusts fast control variables (ignition or injection time) to compensate for deviations in the cylinder initial conditions from their optimal values due to the ...