Heat dissipation in 3D printed cellular aluminum nitride structures
نویسندگان
چکیده
The improvement of heat dissipation in electronic and energy devices is a challenge that can be addressed through the use highly porous materials. Presently, additive manufacturing 3D aluminum nitride described, different lattice patterns with porosities range 45–64 % are achieved by direct ink writing. All structures robust effective thermal conductivity (keff) for cuboid decreases 50–75 filament separation shows anisotropic characteristics, since keff along longitudinal axis scaffold up to six times greater than transversal one. Heat transfer during free cooling experiments cylinder scaffolds, after rapid heating at temperatures above 1000 °C, takes place radiation >500 °C convection complete process. time constants both processes decrease almost linearly designed parameters porosity rod separation.
منابع مشابه
Iron and Nickel Cellular Structures by Sintering of 3D-Printed Oxide or Metallic Particle Inks
Inks comprised of metallic Fe or Ni powders, an elastomeric binder, and graded volatility solvents are 3D-printed via syringe extrusion and sintered to form metallic cellular structures. Similar structures are created from Fe2O3 and NiO particle-based inks, with an additional hydrogen reduction step before sintering. All sintered structures exhibit 92–98% relative density within their struts, w...
متن کاملBoron-nitride and aluminum-nitride "Pringles" and flapping motion.
Motivated by the recent successful synthesis of a new nanocarbon, namely, a warped, double-concave graphene "Pringle" (Nat. Chem., 2013, 5, 739), we investigate properties of warped boron-nitride (BN) and aluminum-nitride (AlN) analogues, i.e., the non-planar B40N40H30 and Al40N40H30 "Pringles" using density functional theory (DFT) calculations. Particular attention is placed on the effect of n...
متن کاملThermal Analysis of Aluminum-Acetone Flat Plate Heat Pipe Application in Heat Dissipation of High Power LEDs
The energy resources of nature are limited. According to the report from the International Energy Agency (IEA), there is 19% of the energy used for illumination. It's well known that LED is an excellent choice to instead the incandescent lamp for saving energy. But the other question comes out while the high power LED is applied. There is only about 20% of the input power converts to light ener...
متن کاملHexagonal boron nitride: a promising substrate for graphene with high heat dissipation.
Supported graphene on a standard SiO2 substrate exhibits unsatisfactory heat dissipation performance that is far inferior to the intrinsic ultrahigh thermal conductivity of a suspended sample. A suitable substrate for enhancing thermal transport in supported graphene is highly desirable for the development of graphene devices for thermal management. By using molecular dynamics simulations, here...
متن کاملAluminum Nitride Piezoelectric Micromachined Ultrasound Transducer Arrays
Air-coupled piezoelectric micromachined ultrasound transducer arrays, operating at ~190 kHz, have been fabricated utilizing an aluminum nitride piezoelectric layer. Improved fabrication processes have reduced the frequency variation seen in our previous work with single transducers resulting in arrays of transducers with resonant frequencies (fn) that match within the fractional half-power band...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The European Ceramic Society
سال: 2021
ISSN: ['0955-2219', '1873-619X']
DOI: https://doi.org/10.1016/j.jeurceramsoc.2020.12.005