Heat Conduction through an Annular Cooling Fin
نویسندگان
چکیده
منابع مشابه
Thermoeconomic Lifecycle Cost Optimization of an Annular Fin Heat Exchanger
In this paper the design of annular fin heat exchanger based on economic optimization has been carried out. The optimization process targeted minimizing the lifecycle cost of annular fin heat exchanger that has the same frontal area, effectiveness and heat load of available practical standard geometry exchangers. The lifecycle cost includes both capital and operating costs. Beside the pumping c...
متن کاملNumerical Optimization of Pin-Fin Heat Sink with Forced Cooling
This study presents the numerical simulation of optimum pin-fin heat sink with air impinging cooling by using Taguchi method. 9 L ( 4 3 ) orthogonal array is selected as a plan for the four design-parameters with three levels. The governing equations are discretized by using the control-volume-based-finite-difference method with a power-law scheme on the non-uniform staggered grid. We solved th...
متن کاملSolid water phantom heat conduction: Heating and cooling rates
Solid water is often the phantom material of choice for dosimetry procedures in radiotherapy high-energy X-ray and electron beam radiation calibration and quality assurance. This note investigates variation in heat conduction that can occur for a common commercially available solid water stack phantom when a temperature differential occurs between the phantom and ambient temperature. These vari...
متن کاملHeat conduction through a DNA-gold composite.
This paper reports results from electrical and thermal conduction measurements carried out on the DNA-gold composite for which the overall conduction is shown to be dominated by the DNA rather than the discontinuous gold coatings. The electrical and thermal conductivities of the composite were about 14 S/cm and 150 W/(m K) at room temperature, respectively. The resulting value of 3.6 x 10(-4) W...
متن کاملAsymmetric heat conduction through a weak link.
We study the heat conduction of two nonlinear lattices joined by a weak harmonic link. When the system reaches a steady state, the heat conduction of the system is decided by the tunneling heat flow through the weak link. We present an analytical analysis by the combination of the self-consistent phonon theory and the heat tunneling transport formalism, and then the tunneling heat flow can be o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1940
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.6.25-2_13