Heat and mass transfer scale-up issues during freeze-drying, III: Control and characterization of dryer differences via operational qualification tests

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Heat and Mass Transfer in Leather Drying Process

Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. Determining drying characteristics of leather is vitally important so as to optimize the drying stage. This paper describes an analytical way for determination of the drying characteristics of leather. The model presented, is based on fundamental heat and mass tra...

متن کامل

Heat Transfer in Freeze-Drying Apparatus

Freeze-drying is a process used to remove water (or another solvent) from a frozen product, thus increasing its shelf-life. It is extensively used in pharmaceuticals manufacturing, to recover the active pharmaceutical ingredient (and the excipients) from an aqueous solution, as well as in some food processes, because of the low operating temperatures that allow preserving product quality. Moreo...

متن کامل

On the computer simulation of heat and mass transfer in vacuum freeze–drying

The paper is devoted to studying the problem of freeze– drying which is a process of the dehydrating frozen materials by sublimation under high vacuum. The mathematical and the computer models describing this process are presented. The discretizations used and the numerical treatment of the corresponding ordinary and partial differential equations is discussed. The results of some test experime...

متن کامل

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

Simulation of Stresses Induced by Heat and Mass Transfer in Drying Process of Clay-like Material

Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: AAPS PharmSciTech

سال: 2006

ISSN: 1530-9932

DOI: 10.1208/pt070239