Heat and mass transfer analysis of developing turbulent flow in a square duct.
نویسندگان
چکیده
منابع مشابه
Flow Analysis Heat and Mass Transfer in a Room
This reports the study on the flow behaviour, heat transfer and contamination distribution in a room. For this purpose the 3-D incompressible Navier-Stokes equations, energy equation and a mass transfer equation which model the concentration of contamination have been applied. For turbulence simulation the two equation standard k- turbulence model was employed. By means of SIMPLE algorithm the...
متن کاملHeat transfer in MHD square duct flow of nanofluid with discrete heat sources
The effect of thermal and solutal buoyancy induced by a discrete source of heat and mass transfer in a square duct under the influence of magnetic field, especially at the turbulent regime for the first time is reported. Al2O3/water nanofluid is used with constant heat flux from three discrete heat sources. In the present study, the effects of Reynolds number (100 to 3000), particle volume frac...
متن کاملnumerical simulation of viscoelastic developing flow and heat transfer in a rectangular duct
this paper presents a numerical simulation of developing flow and heat transfer of a viscoelastic fluid in a rectangular duct. in fully developed flow of a viscoelastic fluid in a non-circular duct, secondary flows normal to the flow direction are expected to enhance the rate of heat and mass transfer. on the other hand, properties such as viscosity, thermal conductivity, specific heat and rela...
متن کاملCharacterisation of Marginally Turbulent Square Duct Flow
We have performed direct numerical simulation of fully developed turbulent flow in a straight duct with square cross-section. The main objective of the present study is to determine the minimal requirements for maintaining turbulence in duct flows [1]. A detailed analysis of this limit regime allows to elucidate the dominant mechanisms governing the marginally turbulent state, where the self-su...
متن کاملHeat and Mass Transfer in Turbulent Multiphase Channel Flow
Direct numerical simulation is used to assess the importance of compressibility in turbulent channel flow of a mixture of air and water vapor with dispersed water droplets. The dispersed phase is allowed to undergo phase transition, which leads to heat and mass transfer between the phases. We compare simulation results obtained with an incompressible formulation with those obtained for compress...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1991
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.57.1044