$\hbox{CrN}_{\rm x}$ Films Prepared by DC Magnetron Sputtering and High-Power Pulsed Magnetron Sputtering: A Comparative Study
نویسندگان
چکیده
منابع مشابه
CrNx Films Prepared by DC Magnetron Sputtering and High-Power Pulsed Magnetron Sputtering: A Comparative Study
CrNx (0 ≤ x ≤ 0.91) films synthesized using highpower pulsed magnetron sputtering, also known as high-power impulse magnetron sputtering (HiPIMS), have been compared with those made by conventional direct-current (dc) magnetron sputtering (DCMS) operated at the same average power. The HiPIMS deposition rate relative to the DCMS rate was found to decrease linearly with increasing emission streng...
متن کاملSuperhard NbB2-x thin films deposited by dc magnetron sputtering
We have deposited weakly textured substoichiometric NbB2-x thin films by magnetron sputtering from a NbB2 target. The films exhibit superhardness (42 ± 4 GPa), previously only observed in overstoichiometric TiB2 thin films, and explained by a self-organized nanostructuring, where thin TiB2 columnar grains hinder nucleation and slip of dislocations and a B-rich tissue phase between the grains pr...
متن کاملPulsed DC Power Supplies for Dual Magnetron Sputtering
Key features of this waveform are the voltage boost period following each polarity transition and fast current rise time due to that boost. Ideally, the boost voltage would be adjustable. It is expected that adjusting the boost voltage will enable some tuning of the film properties, since it will effectively allow tuning of ion energy within the process. Additionally, adjustable duty, the ratio...
متن کاملAlNXOY THIN FILMS DEPOSITED BY DC REACTIVE MAGNETRON SPUTTERING
AlNxOy thin films were produced by DC reactive magnetron sputtering, using an atmosphere of argon and a reactive gas mixture of nitrogen and oxygen, for a wide range of partial pressures of reactive gas. During the deposition, the discharge current was kept constant and the discharge parameters were monitored. The deposition rate, chemical composition, morphology, structure and electrical resis...
متن کاملDEPOSITION OF THIN TiO2 FILMS BY DC MAGNETRON SPUTTERING METHOD
Sputter deposition process is another old technique being used in modern semiconductor industries. Sputtering is a process that can deposit TiO2 material on wafer/glass substrates. In this process target is connected to negative high voltage. Further argon gas is introduced into the chamber and is ionized to a positive charge. The positively charged argon atoms are attracted and strike the nega...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Plasma Science
سال: 2010
ISSN: 0093-3813
DOI: 10.1109/tps.2010.2071885