Hardness and wear of hot-pressed Fe-Cr-Mo-C-Si amorphous alloy powders.
نویسندگان
چکیده
منابع مشابه
Effect of Wet and Dry Conditions on Wear Behavior of Amorphous Coating of Fe-Cr-Mo-Nb-C-B
Recently, wear resistant properties of metallic glasses has attracted a lot of interest. Because the surface of metallic glasses are prone to phase transformation, finding the effects of test condition on structure and wear behavior of metallic glasses is important. In this research, by using an automated electrospark deposition (ESD), a layer of Fe51Cr18Mo7B16C4Nb4 was deposited on AISI 316l s...
متن کاملStability of eutectic carbide in Fe-Cr-Mo-W-V-C alloy
The stability of the eutectic carbide in a self-designed Fe-Cr-Mo-W-V-C alloy during solidifi atio as a alyzed i this ork. The ar ide pre ipitatio rule of the steel was calculated by Thermo-Calc.The typical microstructures at 1240 °C and 1200 °C ere o ser ed y opti al i ros ope OM ,field e issio s a i g ele tro microscope (FESEM) and transmission electron microscope (TEM). The selected area dif...
متن کاملHydrogen Effects on an Amorphous Fe-Si-B Alloy
HYDROGEN interaction with amorphous alloys has Ribbons (,25-mm thick) of amorphous Fe80B11Si9 were been studied extensively due to both scientific and technoused for this research. The ribbons were produced by planarlogical interest. In the framework of a more comprehensive flow casting and were kindly supplied by AlliedSignal Inc. investigation of hydrogen interaction with amorphous and (Parsi...
متن کاملMo-Si-B Alloy Development
Alloys consisting of the phases α-Mo (Mo solid solution), Mo3Si, and Mo5SiB2 (“T2”) were fabricated by ingot and powder metallurgy. A novel powder-metallurgical processing technique was developed which allows the fabrication of silicide alloys with a continuous α-Mo matrix. In these alloys the relatively ductile and tough α-Mo matrix acts as a “binder” for brittle silicide particles. An alloy p...
متن کاملMechanism of Bainite Transformation in Fe-Cr-Mo-V-Ti-C Steel
The kinetics and mechanism of bainite transformation have been studied in Fe-Cr-Mo-V-Ti-C steel high speed dilatometry backed by thermodynamic analysis. The complete transformation of austenite, however, has not occurred at any reported temperature. Obtained results confirm the incomplete reaction phenomenon with the cessation of the bainite transformation well before the paraequilibrium is ach...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Iron and Steel Institute of Japan
سال: 1988
ISSN: 0021-1583,1881-1183
DOI: 10.2355/isijinternational1966.28.7