Hard Machinable Machining of Cobalt Super Alloys
نویسندگان
چکیده
منابع مشابه
Mechanical Properties of Electroformed Nickel Cobalt Alloys
Mechanical properties of nickel-cobalt alloys (0-10% Co) electroformed with low internal stress in sulfamate-based solutions were investigated in as deposited and heat treated conditions. It was demonstrated that alloy properties can be modified by selecting deposition conditions and alloy composition. Recommendations on alloy selection are made based on application requirements. The higher str...
متن کاملMagnetism of Less Common Cobalt-Rich Alloys
Alternative permanent-magnet materials with intermediate performance, such as K1 , are investigated experimentally. Our focus is on the structural and magnetic properties of bulk YCo5-xFex and on rare-earth-free transition-metal alloys such as TMxCo100-x (TM = Zr, Hf). YCo5-xFex alloys (x = 0 to 0.75), which crystallize in the hexagonal CaCu5-type structure, exhibit an improved of anisotropy an...
متن کاملCobalt-base ferromagnetic shape memory alloys
Single crystalline and polycrystalline CoxNiyGa100-(x+y), 41<xCo<62 and 19.3<xNi<32.7 [at%], Ferromagnetic Shape Memory Alloys (FMSMAs) have been produced in the range of the Heusler-type composition. Elasto-mechanical properties have been analyzed for the annealed and quenched states, respectively. The mechanical spectroscopy data show the occurrence of martensitic phase transformations with t...
متن کاملA Review on High-Speed Machining of Titanium Alloys∗
Titanium alloys have been widely used in the aerospace, biomedical and automotive industries because of their good strength-to-weight ratio and superior corrosion resistance. However, it is very difficult to machine them due to their poor machinability. When machining titanium alloys with conventional tools, the tool wear rate progresses rapidly, and it is generally difficult to achieve a cutti...
متن کاملOn High Speed Machining of Titanium Alloys - Analysis and Validation
III ABSTRACT This report documents the steps taken to gain insight into the phenomena of high speed machining (HSM) of titanium alloys. This was done by firstly studying titanium alloys and the problems associated with machining titanium alloys. An experimental set-up and procedure was developed for measuring and recording both the machining temperature and component forces. A sufficient set of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scientific Proceedings Faculty of Mechanical Engineering STU in Bratislava
سال: 2012
ISSN: 1338-5011,1338-1954
DOI: 10.2478/v10228-012-0007-6