H∞ Based Control for Load Mitigation in Wind Turbines
نویسندگان
چکیده
منابع مشابه
Optimal control for load alleviation in wind turbines
Nowadays, trailing edge flaps on wind turbine blades are considered to reduce loading stresses in wind turbine components. In this paper, an optimal control synthesis methodology for the design of gust load controllers for large wind turbine blades is proposed. We discuss a control synthesis approach that minimises the power expenditure of the actuated trailing edge flap, while at the same time...
متن کاملMitigation of Asymmetrical Grid Faults in Induction Generator-Based Wind Turbines Using Constant Power Load
Constant power loads (CPLs), interfaced through active rectifiers can be used for improving the stability of induction generator (IG)-based wind turbines under balanced grid voltage dips by providing the reactive power. Under asymmetrical grid faults, the negative sequence voltage produces additional generator torque oscillations and reduces the lifetime of the installed equipment. This article...
متن کاملNonlinear Dynamic Inversion Control for Wind Turbine Load Mitigation based on Wind Speed Measurement
The design of an advanced controller for wind turbine load mitigation is presented. The controller is based on Nonlinear Dynamic Inversion control methods combined with Pseudo Control Hedging to account for the actuator limits and a two degree of freedom control system for the collective pitch control of the rotor blades. The controller uses wind speed measurement information to adjust to wind ...
متن کاملPreview Control for Wind Turbines
The success of wind power as a renewable energy source depends on its cost of energy. Wind turbine control has attracted much attention in the controls community due to its potential impact on the cost of wind power. However, novel methods in the literature have not transitioned well to industry. This is because the potential cost benefits of these methods are not well understood. There is a ne...
متن کاملLoad Reduction Pitch Control for Large Scale Wind Turbines based on Sliding Mode
With the wind turbines being produced toward to large scale and light weight, the flexibility of blade, drive mechanism and tower increase apparently. Loads suffered by wind turbines during operation become increasingly intricate. Some control approaches could be used to cut down these loads in orde to expand life cycle of generating sets. Aiming at the full load operation zone above rated wind...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energies
سال: 2012
ISSN: 1996-1073
DOI: 10.3390/en5040938