Growth Isotherms of Liquid-Phase Sintered Silicon Nitride
نویسندگان
چکیده
منابع مشابه
Structural and Electrical Characterization of Sintered Silicon Nitride Ceramic
The electrical conduction phenomena, dielectric response and microstructure have been discussed in sintered silicon nitride ceramics at different temperature and frequencies. Microstructure and phase of the sintered samples was investigated by Scanning Electron Microscope (SEM) and X-ray diffractometer (XRD). The electrical conductivity, dielectric constant and dielectric loss increases exponen...
متن کاملMicrostructure of Spark Plasma-Sintered Silicon Nitride Ceramics
The microstructure and phase composition of the high-content Al2O3-Y2O3-doped spark plasma-sintered silicon nitride were investigated. Fully dense silicon nitride ceramics with a typical α-Si3N4 equiaxed structure with average grain size from 200 to 530 nm, high elastic modulus of 288 GPa, and high hardness of 2038 HV were spark plasma sintered (SPSed) at 1550 °C. Silicon nitride with elongated...
متن کاملMicrostructure and Phase Composition of Cold Isostatically Pressed and Pressureless Sintered Silicon Nitride.
The microstructure and physical properties of new Y2O3 and Al2O3 oxide-doped silicon nitride ceramics fabricated by cold isostatic pressing and free sintering were investigated. The phase composition of produced material was also studied by X-ray diffraction at room and elevated temperature. The fabricated ceramics featured a microstructure of Si5AlON7 grains with a fine-grained α-Si3N4 with a ...
متن کاملInterfacial structure in silicon nitride sintered with lanthanide oxide
Three independent research groups present a comparison of their structural analyses of prismatic interfaces in silicon nitride densified with the aid of lanthanide oxide Ln2O3. All three groups obtained scanning transmission electron microscope images which clearly reveal the presence of well-defined Ln segregation sites at the interfaces, and, moreover, reveal that these segregation sites are ...
متن کاملPattern Photoresist Silicon Silicon Nitride Silicon Photoresist Silicon Nitride Silicon Etch Nitride Remove Photoresist
In this proposal we seek to establish a porous silicon based etching process in the WTC microfabrication laboratory. The new process will allow us to etch high aspect ratio holes through a wafer. Holes like these are important for decreasing the dead volume of connections between micro and macro systems and for increasing the complexity of micro-fluidic systems. At the present time, the minimum...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 1997
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.105.638