Ground Thermal Response and Recovery after Heat Injection: Experimental Investigation
نویسندگان
چکیده
منابع مشابه
Experimental Investigation of Thermal Balance and Valve Cover Heat Transfer in a Small Internal Combustion Engine
Heat transfer in internal combustion engines is one of the most significant topics. Heat transfer may take place through thermal conduction and thermal convection in spark ignition engines. In this study, valve cover heat transfer and thermal balance of an air-cooled engine are investigated experimentally. The thermal balance analysis is a useful method to determine energy distribution and effi...
متن کاملNumerical and Experimental Investigation of Thermal Debinding
Powder injection molding (PIM) is an important netshape manufacturing process and has received much attention. One of the most critical steps in PIM process is debinding. It consumes a major part of the processing time. Failure of the powder compact often results if the process is accelerated. Thermal debinding is a common methodology for the final removal of residual polymer from a PIM compact...
متن کاملExperimental Investigation on Hydrodynamic and Thermal Performance of a Gas-Liquid Thermosyphon Heat Exchanger in a Pilot Plant
Waste heat recovery is very important, because not only it reduces the expenditure of heat generation, but also it is of high priority in environmental consideration, such as reduction in greenhouse gases. One of the devices is used in waste heat recovery is heat pipe heat exchanger.Anexperimental research has been carried out to investigate the hydrodynamic and thermal performance of a gas...
متن کاملExperimental Investigation on the Performance of Ground-source Heat Pump with the Refrigerant R410A
Nowadays, in some small and medium-sized heat pumps, refrigerant R410A has been used widely because of the good thermodynamic performance and environmental protection. Firstly the principles of the system and the characteristics of refrigerant has been demonstrates. The paper has set up a heat pump system with the refrigerant R410A and the performance parameters under different working conditio...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of FAMENA
سال: 2018
ISSN: 1333-1124,1849-1391
DOI: 10.21278/tof.42si104