Grindarbility of Sintered Alumina with Different Porosity.
نویسندگان
چکیده
منابع مشابه
Microstructure and mechanical properties of pressureless sintered alumina-silver composites
The silver toughened alumina ceramics, which were fabricated via a conventional ceramic processing route using commercially available alumina and silver oxide powders as the starting materials, exhibit a higher fracture toughness (6 to 9 MPamo.5) than the monolithic alumina ceramic ( 2.5 to 3.0 MPamo.5). The weak interfacial bonding between the silver inclusions and the alumina matrix is charac...
متن کاملComparison of different segmentation methods for porosity evaluation in CFRP-reference samples with real porosity samples
The main objective of this work is quantitative evaluation of porosity in carbon fiber reinforced polymers (CFRP) with the help of X-ray computed tomography (XCT). For this purpose two types of sample were compared. Industrial porosity sample was obtained from an aeronautical industry. Artificially induced porosity samples were created by drilling holes with diameter 0.2 mm and 0.3 mm in non-po...
متن کاملCellular Response to Doping of High Porosity Foamed Alumina with Ca, P, Mg, and Si
Foamed alumina was previously synthesised by direct foaming of sulphate salt blends varying ammonium mole fraction (AMF), foaming heating rate and sintering temperature. The optimal product was produced with 0.33AMF, foaming at 100 °C/h and sintering at 1600 °C. This product attained high porosity of 94.39%, large average pore size of 300 µm and the highest compressive strength of 384 kPa. To i...
متن کاملCharacterization of porosity of isostatically pressed and sintered nickel-base powdered metal.
Characterization of the pore structure of compacted and sintered parts made from a nickel-base powder was accomplished using the mercury porosimetry method. The theoretical density values for the sintered specimens varied from 56.3 to 96.7% which corresponds to a porosity of 43.7 to 3.3%. A maximum interconnecting median pore diameter of 21 mum resulted from a -80/+200 mesh powder compacted at ...
متن کاملThe measurement of coal porosity with different gases
Sorption processes can be used to study different characteristics of coal properties, such as gas content (coalbed methane potential of a deposit), gas diffusion, porosity, internal surface area, etc. Coal microstructure (porosity system) is relevant for gas flow behaviour in coal and, consequently, directly influences gas recovery from the coalbed. This paper addresses the determination of coa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1999
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.46.325