Green phase difference coding with low switching activity for Network-on-Chip
نویسندگان
چکیده
منابع مشابه
Design of a Low-Latency Router Based on Virtual Output Queuing and Bypass Channels for Wireless Network-on-Chip
Wireless network-on-chip (WiNoC) is considered as a novel approach for designing future multi-core systems. In WiNoCs, wireless routers (WRs) utilize high-bandwidth wireless links to reduce the transmission delay between the long distance nodes. When the network traffic loads increase, a large number of packets will be sent into the wired and wireless links and can...
متن کاملWireless MIMO Switching with Network Coding
In a generic switching problem, a switching pattern consists of a one-to-one mapping from a set of inputs to a set of outputs (i.e., a permutation). We propose and investigate a wireless switching framework in which a multi-antenna relay is responsible for switching traffic among a set of N stations. We refer to such a relay as a MIMO switch. With beamforming and linear detection, the MIMO swit...
متن کاملLow-power and error protection coding for network-on-chip traffic
The power consumption of the network-on-chip communication backbone is explored and the effectiveness of low-power encoding and error protection techniques is analysed. For the switch under the study, a Nostrum deflective routing switch, simulations and power analysis suggest that only a minor fraction of the power is dissipated in the logic blocks, whereas the major part is due to the intercon...
متن کاملdesign of an analog ram (aram)chip with 10-bit resolution and low-power for signal processing in 0/5m cmos process
برای پردازش سیگنال آنالوگ در شبکه های عصبی ، معمولا نیاز به یک واحد حافظه آنالوگ احساس میشود که بدون احتیاج به a/d وd/a بتواند بطور قابل انعطاف و مطمئن اطلاعات آنالوگ را در خود ذخیره کند. این واحد حافظه باید دارای دقت کافی ، سرعت بالا ، توان تلفاتی کم و سایز کوچک باشد و همچنین اطلاعات را برای زمان کافی در خود نگهدارد. برای پیاده سازی سیستمی که همه این قابلیتها را در خود داشته باشد، کوشش...
15 صفحه اولLow Power CMOS Off-Chip Drivers with Slew-rate Difference
This paper proposes an approach to reduce the short circuit current of CMOS off-chip drivers by individually controlling the input slew rates to the P and N channel transistors that drive the output pad. The slew rates are deliberately designed such that the N(P) transistor at the output stage will be turned off faster than the P(N) transistor is turned on for low-to-high (highto-low) output tr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2015
ISSN: 1349-2543
DOI: 10.1587/elex.12.20150480