Graphene bolometer with thermoelectric readout and capacitive coupling to an antenna
نویسندگان
چکیده
منابع مشابه
Ultra Wideband Monopole Antenna Excited by a Capacitive Coupling Feed with Double Band Notch Function
This paper presents the results of a new monopole antenna that exhibits 2.75-10.7 GHz performance. The proposed antenna consists of a radiating patch with notches excited by capacitive coupling feed. Also, the antennas truncated ground-plane incorporates a central notch. This modification significantly improves the antennas impedance bandwidth by 118% over an ultra-wideband frequency range. T...
متن کاملAntenna-coupled Bolometer Arrays for Astrophysics
We are developing arrays of feedhorn-coupled, silicon nitride micromesh (‘spider web’) bolometers for the ESA/NASA Planck Surveyor and Herschel Space Observatory for millimeter to far-infrared wavelengths. These detector systems realize high end-to-end optical efficiency, essentially fill the available focal surface, and achieve background-limited sensitivity. The Planck/HFI detectors in partic...
متن کاملTransition-edge superconducting antenna-coupled bolometer
We report test results for a single pixel antenna-coupled bolometric detector. Our device consists of a dual slot microstrip antenna coupled to an Al/Ti/Au voltage-biased transition edge superconducting bolometer (TES). The coupling architecture involves propagating the signal along superconducting microstrip lines and terminating the lines at a normal metal resistor colocated with a TES on a t...
متن کاملCmos Readout Interfaces for Mems Capacitive Microphones
This dissertation demonstrates the feasibility of three novel low-power and low-noise schemes for the readout interfaces of MEMS Capacitive Microphones (MCM) by presenting their detailed design descriptions and measurement results as application-specific ICs (ASIC) in CMOS technology developed to exploit their application scope in consumer electronics and hearing aids. MCMs are a new generation...
متن کاملImproved Circuits with Capacitive Feedback for Readout Resistive Sensor Arrays
One of the most suitable ways of distributing a resistive sensor array for reading is an array with M rows and N columns. This allows reduced wiring and a certain degree of parallelism in the implementation, although it also introduces crosstalk effects. Several types of circuits can carry out the analogue-digital conversion of this type of sensors. This article focuses on the use of operationa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics Letters
سال: 2018
ISSN: 0003-6951,1077-3118
DOI: 10.1063/1.5009629