Grain Size Dependence of Magnetic Properties in Mild Steels.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Grain-size dependence of intergranular magnetic correlations in nanostructured metals

Magnetic small-angle neutron scattering experiments were performed on nanostructured Fe, Co and Ni samples of varying grain size, produced by inert-gas condensation. The experiments show that the spontaneous spatial magnetic correlations forming in zero-field extend over many individual grains. These correlations depend strongly on grain size. In Fe, they have a minimum at a grain size of aroun...

متن کامل

Grain size dependence of magnetic properties in shock synthesized bulk Pr2Fe14B/a-Fe nanocomposites

The structural and magnetic properties of the melt-spun Pr2Fe14B/a-Fe nanocomposite powders consolidated via shock-wave compression and subjected to postshock thermal treatment were investigated. Shock compression results in grain refinement, which leads to a reduction of an effective anisotropy and therefore an increase in the ferromagnetic exchange length, resulting in an enhanced exchange co...

متن کامل

Size Dependence of Structures and Properties of Magnetic Materials

Due to the involvement of high portion of atomic coordination imperfection in surfaces and interfaces, the properties of magnetic nanocrystals dramatically differ from that of the corresponding bulk counterparts, which have led to a surge in both experimental and theoretical investigations in the past decades. This review summarizes the studies for these size-dependent magnetic properties, and ...

متن کامل

The Effect of Ferrite Grain Size on the Fatigue Behavior of Ferrite-martensite Dual-phase Steels

The effect of ferrite grain size on the fatigue and tensile properties of dual phase steels with a 0.25 volume fraction of martensite (Vm) under different heat treatments was investigated. The heat treatments were homogenized at 1200 oC along with several subsequent normalizations at 910 oC, resulting in different microstructures and mechanical properties. After heat treatment, the obtained ste...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A

سال: 1999

ISSN: 0387-5008,1884-8338

DOI: 10.1299/kikaia.65.100