Grain Refinement of Continuously Cast Aluminum Ingot Using a Heating Oscillator
نویسندگان
چکیده
منابع مشابه
Effects of Homogenization Conditions and Hot Rolling Parameters on Grain Refinement of an As-Cast 301 Stainless Steel
In this work, effects of homogenization time of 3 to 13 h at 1200 °C on the grain refinement of as-cast AISI 301 stainless steel after different hot rolling conditions were investigated. The results showed that the minimum grain size of 16±7 mm was achieved when homogenization took place at 1200 °C for 9 h followed by hot rolling at temperature range of 1000–1200 °C with strain of 0.8 and stra...
متن کاملStudying as - Cast Microstructure of the Cold Core (cc) Ingot
X. J. Zhang, C. J. Xu (Corresponding Author), Z. Y. Wang, J. Li, L. W. Zhang, X.D. Peng. School of Materials and Metallurgy, University of Science and Technology Liaoning, China In this study, the mechanism of the formation in structure of Cold Core ingot which is prepared by cold core casting method in lab is studied. The structure of the CC ingot is obtained by optical microscopy and macrosco...
متن کاملGrain refinement, Microstructural characterization, and tensile properties of die-cast AZ91 alloy via Lead and Tin additions
Effects of different amounts of lead (Pb) and tin (Sn) on microstructure and tensile properties of the AZ91 alloy were studied. The results presented that the microstructure of AZ91 alloy is consisted the α-Mg phase and semi-continuous network of β-Mg17Al12 intermetallics. For the as-cast AZ91 alloy, the average grain siz and the β phase volume fraction were 96.2 µm and of 25.3%, respectively. ...
متن کاملMagnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling
The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...
متن کاملResidual Stress Measurements of Cast Aluminum Engine Blocks Using Diffraction
Residual stresses and strains in as-cast and annealed aluminum engine blocks were mapped in the main web area above the bearing split using diffraction. Automated coordinate-mapping of the surface and bulk strains was accomplished with X-ray and neutron diffraction, respectively. LabVIEW-based software was developed for improved efficiency, flexibility and quality of data analysis. In the hoop ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1987
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.51.4_370