Grain refinement of cast Mg-Al alloys.

Magnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling

The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...

THERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS

Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...

Fluidized Bed Heat Treatment of Cast Al-Si-Cu-Mg Alloys

The effects of fluidized bed heat treatment on the microstructural and mechanical properties of Al-Si-Cu-Mg cast alloys, namely,3 54 and 319, were studied. The heating rate in fluidized beds (FBs) is greater vis-a`-vis conventional electrical resistancef urnaces (CFs). The high heating ratei nF Bs increases the kinetics of metallurgical phenomena such as Si fragmentation and spherodization duri...

Precipitation Hardening of Al–Si–Mg Alloys

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...