Grain Refinement by Low Temperature Rolling and Subsequent Annealing Process
نویسندگان
چکیده
منابع مشابه
Magnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling
The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...
متن کاملInfluence of Process Parameters on Grain Refinement in AA1050 Aluminum During Cold Rolling
The microstructure evolution during cold rolling of commercial purity AA1050 aluminum is investigated through numerical simulations. A finite strain elasto-viscoplastic constitutive model is employed, where the dislocation density and average grain size are taken as variables characterizing the deformed microstructure. Grain size evolution due to dynamic recrystallization is considered and the ...
متن کاملPreparation of Some Specific Grain Boundaries in Aluminum for Hrem Studies by Cold Rolling and Annealing
The preparation of bicrystals with an aim to study grain boundary structure by high resolution electron microscopy (HREM) requires a careful approach. Primary attention needs to be directed towards the orientations of the crystals forming a boundary so that atomic resolution images of the bicrystai can be achieved by HREM. Mader, Necker and Bailuffi (1) have reviewed the limitations of present ...
متن کاملEffects of Homogenization Conditions and Hot Rolling Parameters on Grain Refinement of an As-Cast 301 Stainless Steel
In this work, effects of homogenization time of 3 to 13 h at 1200 °C on the grain refinement of as-cast AISI 301 stainless steel after different hot rolling conditions were investigated. The results showed that the minimum grain size of 16±7 mm was achieved when homogenization took place at 1200 °C for 9 h followed by hot rolling at temperature range of 1000–1200 °C with strain of 0.8 and stra...
متن کاملFive-parameter grain boundary analysis of a titanium alloy before and after low-temperature annealing
The five-parameter grain boundary analysis has been applied for the first time to a titanium alloy. The boundary distribution was related to the b-to-a phase transformation and to deformation twinning. There was a very strong planes texture, only partially related to twinning, which did not diminish during long-duration, low-temperature annealing. 2007 Acta Materialia Inc. Published by Elsevier...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1993
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.79.5_611