Graft polymerization of MMA onto the styrene elastomers and mechanical properties of graft polymer and blend polymer.
نویسندگان
چکیده
منابع مشابه
determination of some physical and mechanical properties red bean
چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...
15 صفحه اولRadiation graft post-polymerization of sodium styrene sulfonate onto polyethylene
Post-irradiation grafting of sodium styrene sulfonate (SSS) in the presence of acrylic acid (AA) has been investigated on polyethylene (PE) pre-exposed to gamma radiation at room temperature in the air. Special attention was paid to the effect of low molecular weight salt additives on the kinetics of graft copolymerization of SSS and AA. The presence of SSS links in the grafted PE copolymers wa...
متن کاملMolecular dynamics simulation on the mechanical properties of natural-rubber-graft-rigid-polymer/rigid-polymer systems.
A coarse-grained model-based molecular dynamics simulation was employed to investigate the mechanical properties of NR-graft-rigid-polymer/rigid-polymer systems (N30-g-(R3)6/R10). An external factor (the strain rate) as well as internal factors such as the nonbonding interaction strength, the proportion of rigid polymers, and architecture parameters (the length and number of graft chains in a m...
متن کاملPES/Quaternized-PES Blend Anion Exchange Membranes: Investigation of Polymer Compatibility and Properties of the Blend
Polyethersulfone (PES)-based anion exchange blend membranes were prepared from quaternized-PES (Q-PES) and N-Methyl-2-pyrrolidone (NMP) casting solutions with water as coagulant via non-solvent induced phase inversion. The compatibility of the blend system was investigated through thermodynamic studies while membrane formation was determined using the cloud point techni...
متن کاملMechanical Properties and Adhesion of a Micro Structured Polymer Blend
A 50:50 blend of polystyrene (PS) and poly(n-butyl methacrylate) (PnBMA) has been characterized with an Atomic Force Microscope (AFM) in Tapping Mode and with force-distance curves. The polymer solution has been spin-coated on a glass slide. PnBMA builds a uniform film on the glass substrate with a thickness of ≅200 nm. On top of it, the PS builds an approximately 100 nm thick film. The PS-film...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 1993
ISSN: 1884-0442,0029-022X
DOI: 10.2324/gomu.66.585