Giant intermetallic compounds in Al-Mg alloys.

Precipitates and intermetallic phases in precipitation hardening Al–Cu–Mg–(Li) based alloys

The present study contains a critical review of work on the formation of precipitates and intermetallic phases in dilute precipitation hardening Al–Cu–Mg based alloys with and without Li additions. Although many suggestions for the existence of pre-precipitates in Al–Cu–Mg alloys with a Cu/Mg atomic ratio close to 1 have been made, a critical review reveals that evidence exists for only two tru...

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...

Precipitation Hardening of Al–Si–Mg Alloys

Melt Protection of Mg-Al Based Alloys

This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...

STRUCTURE OF STABLE INTERMETALLIC COMPOUNDS OF THE Al-Li-Cu-(Mg) AND Al-Li-Zn-(Cu) SYSTEMS

The results of a thorough structural study of crystalline intermetallic compounds within the Al-Li-(Cu,Mg,Zn) system are given. Characteristic morphologies of these ternary or quaternary phases are exhibited by concentrated alloys or large single crystals. Typical X-ray powder diffraction data, selected area electron diffraction patterns and high resolution electron microscopy images are shown,...