Gas Wiping Mechanism in Hot-Dip Coating Process
نویسندگان
چکیده
منابع مشابه
Interferometric monitoring of dip coating.
Dip-coated films, which are widely used in the coating industry, are usually measured by capacitive methods with micrometric precision. For the first time to our knowledge, we have applied an interferometric determination of the evolution of thickness in real time to nonvolatile Newtonian mineral oils with several viscosities and distinct dip withdrawing speeds. The evolution of film thickness ...
متن کاملEffect of Chemical Composition of Steel on the Structure of Hot – Dip Galvanized Coating
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – University of Chemistry and Technology, Prague, Czech Republic This article describes the effect of the content of conventional steel impurity elements on the thickness and composition of the zinc layer. This article is focused primarily on low-temperature, batch hot-dip galvaniz...
متن کاملSelective dip-coating of chemically micropatterned surfaces
We characterize the selective deposition of liquid microstructures on chemically heterogeneous surfaces by means of dip coating processes. The maximum deposited film thickness depends critically on the speed of withdrawal as well as the pattern size, geometry, and angular orientation. For vertically oriented hydrophilic strips, we derive a hydrodynamic scaling relation for the deposited film th...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملConformal dip-coating of patterned surfaces
Capillarity-driven self-assembly of small chips onto planar target substrates is a promising alternative to robotic pick-and-place assembly. It critically relies on the selective deposition of thin fluid films on patterned binding sites, which is anyway normally non-conformal. We found that the addition of a thin wetting sidewall, surrounding the entire site perimeter, enables the conformal flu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1995
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.81.6_643