Gas holdup and volumetric liquid-phase mass transfer coefficient in bubble column with draught tube and with gas dispersion into tube.

experimental investigation of power consumption, mass transfer coefficient and flow regime in gas-liquid dispersion systems

Determination of Volumetric Mass Transfer Coefficient in Gas-Solid-Liquid Stirred Vessels Handling High Solids Concentrations: Experiment and Modeling

Rigorous analysis of the determinants of volumetric mass transfer coefficient (kLa) and its accurate forecasting are of vital importance for effectively designing and operating stirred reactors. Majority of the available literature is limited to systems with low solids concentration, while there has always been a need to investigate the gas-liquid hydrodynamics in tanks handling ...

Gas-Liquid Interfacial Area, Bubble Size and Liquid-Phase Mass Transfer Coefficient in a Three-Phase External Loop Airlift Bubble Column

The interfacial area a was measured by the sulfite oxidation method in a three-phase external loop airlift bubble column suspending completely the different concentrations of ion exchange resin particles in aqueous carboxymethyl cellulose (CMC) solutions with a wide range of viscosity. The column had been previously studied for the circulating liquid velocity UL, gas holdup G and volumetric gas...

Gas holdup in a gas-liquid-fiber semi-batch bubble column

A 4-m high, 15.24-cm diameter semi-batch bubble column connected to one of three perforated plate gas distributors with open area ratios A = 0.57%, 0.99%, and 2.14% is employed to study gas holdup and flow regime in Rayon and Nylon fiber suspensions. This study determines the effect of superficial gas velocity, fiber type, fiber mass fraction, fiber length, and aeration plate open area ratio on...

Gas-liquid mass transfer coefficient in stirred tanks interpreted through bubble contamination kinetics

Experimental data on the average mass transfer liquid film coefficient (kL) in an aerated stirred tank are presented. Liquid media used were tap water, electrolyte solutions and water with controlled addition of tensioactive material. Values of kL range from those expected for bubbles with a mobile surface to those expected for rigid bubbles. These data are quantitatively interpreted in terms o...