Gas Engine and Its Lubrication-Unresolved Phenomena in Lubrication and Their Clarifications
نویسندگان
چکیده
منابع مشابه
Engine Lubrication Oil Aeration
The lubrication system of an internal combustion engine serves many purposes. It lubricates moving parts, cools the engine, removes impurities, supports loads, and minimizes friction. The entrapment of air in the lubricating oil is called oil aeration. Oil aeration can be detrimental to internal combustion (IC) engines. This study attempts to determine a means to reduce the level of aeration in...
متن کاملElectric Phenomena in Relation to Lubrication
General. The effect of shaft currents passing through an oil film in a bearing is to accelerate polymerization and oxidation and cause thermal decomposition. The oil darkens in colour, sometimes increases in acidity, and generally deposits a chocolate-colour precipitate in the oil system. Arcing will also cause small particles of metal to flake off and contaminate the oil. If a shaft current is...
متن کاملSoft lubrication.
We consider some basic principles of fluid-induced lubrication at soft interfaces. In particular, we quantify how a soft substrate changes the geometry of and the forces between surfaces sliding past each other. By considering the model problem of a symmetric nonconforming contact moving tangentially to a thin elastic layer, we determine the normal force in the small and large deflection limit,...
متن کاملFriction and Lubrication
FRICTION AND LUBRICATION in sheet metal forming are influenced by such parameters as material properties, surface finish, temperature, sliding velocity, contact pressure, and lubricant characteristics. The parameters that affect friction and lubrication are schematically shown in Fig. 7.1. Depending on these parameters, the performance of a lubricant and the coefficient of friction (COF) vary. ...
متن کاملHydrodynamic and Elastohydrodynamic Lubrication
Contents 1. Introduction 2. Stress-induced lubricant degradation 3. Basic equations governing the fluid elastohydrodynamic lubrication (EHL) of line and point contacts 3.1. Equations of fluid motion 3.2. Contact surface displacements in line and point lubricated contacts 4. Steady isothermal EHL problems for lightly loaded non-conformal line contacts 5. Steady isothermal EHL problems for heavil...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Japan Institute of Marine Engineering
سال: 2007
ISSN: 1346-1427,1884-3778
DOI: 10.5988/jime.42.3_433