Gas-abrasive wear resistance of silicon and boron carbonitride films
نویسندگان
چکیده
منابع مشابه
Compilation on Synthesis, Characterization and Properties of Silicon and Boron Carbonitride Films
During the last years the interest in silicon and boron carbonitrides developed remarkably. This interest is mainly based on the extraordinary properties, expected from theoretical considerations. In this time significant improvements were made in the synthesis of silicon carbonitride SiCxNy and boron carbonitride BCxNy films by both physical and chemical methods. In the Si–C–N and B-C-N ternar...
متن کاملEffect of Abrasive Particle Size on Abrasive Wear Resistance in Otomotive Steels
If one of the surfaces which are in touch is rough and hard, it chips the other surface due to relative motion or touching forces. The wear is called two-body abrasive wear. If there are free abrasive particles between the two bodies, the wear is called three-body abrasive wear. The free abrasive particles may be external material dust or the remains of chipping. Usually, the wear starts as a t...
متن کاملFacile Synthesis of Ternary Boron Carbonitride Nanotubes
In this study, a novel and facile approach for the synthesis of ternary boron carbonitride (B-C-N) nanotubes was reported. Growth occurred by heating simple starting materials of boron powder, zinc oxide powder, and ethanol absolute at 1150 degrees C under a mixture gas flow of nitrogen and hydrogen. As substrate, commercial stainless steel foil with a typical thickness of 0.05 mm played an add...
متن کاملTHE EFFECT OF HEAT TREATMENT ON ABRASIVE WEAR RESISTANCE OF Fe-34Cr-4.5C%WT HARDFACING ALLOY
Abstract: Hardfacing is one of the most useful and economical ways to increase the service life of components subjected to abrasive wear. Iron based hardfacing alloys have long been considered as candidate coatings for wear-resistant applications in industry. In the present work two layer of Fe-34Cr-4.5C%wt hardfacing alloy was deposited on ASTM A36 carbon steel plates by SMAW method. The m...
متن کاملModelling Friction and Abrasive Wear of Elastomers
In order to properly model the friction and wear of elastomer materials, it is essential to understand some specific mechanical and tribological features. Mechanical characteristics of elastomer materials are different from those of metals and other relatively hard materials. Elastomers can bear large deformations, the stress-strain curves are non-linear, time and temperature dependent. When th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Letters on Materials
سال: 2017
ISSN: 2218-5046,2410-3535
DOI: 10.22226/2410-3535-2017-3-272-277