Gain-Scheduling Controller Synthesis Based on Descriptor Representations
نویسندگان
چکیده
منابع مشابه
Gain-Scheduled Controller Synthesis Based on New LMIs for Dissipativity of Descriptor LPV Systems
This paper is concerned with synthesis of gain-scheduled controllers by representing LPV systems in the descriptor form. Based on a recent algebraic criterion characterizing dissipativity of descriptor systems, an improved synthesis method is proposed with removing limitations of descriptor representation in existing results. Specifications of exponential decay are also considered. A numerical ...
متن کاملGain Scheduling Based Fuzzy Controller Design
AbstructThis paper presents a gain scheduling based approach to the design of fuzzy controllers. We demonstrate that the Sugeno fuzzy controller is in fact a special case of gain scheduling where the feedback gains are adjusted (“scheduled”) via membership functions in fuzzy if-then rules. When the desired gains at various operating points are available, we can apply the ANFIS learning algorith...
متن کاملGain Scheduling of PID Controller Based on Fuzzy Systems
This paper aims to utilize fuzzy rules and reasoning to determine the controller parameters and the PID controller generates the control signal. The objective of this study is to simulate the proposed scheme on various processes and arrive at results providing better response of the system when compared with best industrial auto-tuning technique: Ziegler-Nichols. The proposed scheme is based up...
متن کاملA PI Controller Based on Gain-Scheduling for Synchronous Generator
In this paper a gainscheduling scheme of a proportional integral (GSPI) controller is proposed for a synchronous generator. In presented scheme, both proportional and integral gains are allowed to vary within a predetermined range. In order to validate the effectiveness of GSPI controller, simulation studies for a single-machine infinite bus power system are used .The results verify improved pe...
متن کاملA Gain Scheduling Controller for Friction Compensation
Friction in mechanical systems can show a very complex behaviour. In addition to its non-linear dependence on the velocity, friction is also function of the position. In the vicinity of motion reversal points, i.e. in the prerolling/pre-sliding regime, the position dependence dominates and appears in the form of a rate-independent hysteresis with nonlocal memory. One of the ways of treating thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Society of Instrument and Control Engineers
سال: 2005
ISSN: 0453-4654
DOI: 10.9746/sicetr1965.41.53