G-Ratio in hardened steel grinding with different coolants
نویسندگان
چکیده
منابع مشابه
Copper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملComparison of Grinding Characteristics of Converter Steel Slag with and without Pretreatment and Grinding Aids
Jihui Zhao 1,*, Dongmin Wang 2, Peiyu Yan 1 and Wenping Li 2 1 Institute of Building Materials, Department of Civil Engineering, Tsinghua University, Beijing 100084, China; [email protected] 2 School of Chemical & Environmental Engineering, China University of Mining & Technology, Beijing 100083, China; [email protected] (D.W.); [email protected] (W.L.) * Correspondence: zhaojihui324@...
متن کاملSurface characterization of austenitic stainless steel 304L after different grinding operations
Background: The austenitic stainless steel 304L is widely used as a structural material for which the finished surface has significant effect on the service performance. A study of the grinding process with regard to the quality of the ground surfaces is therefore interesting from the point of view of both industrial application and scientific research. Method: This work investigates the influe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2012
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/x.2012/a/1213-2489/mt/12/2/192