Fused Deposition Modelling of high temperature polymers: Exploring CNT PEEK composites
نویسندگان
چکیده
منابع مشابه
High Temperature Graphene-peek Adhesive
........................................................................................................................................... i Table of
متن کاملFilaments Production and Fused Deposition Modelling of ABS/Carbon Nanotubes Composites
Composite acrylonitrile-butadiene-styrene (ABS)/carbon nanotubes (CNT) filaments at 1, 2, 4, 6 and 8 wt %, suitable for fused deposition modelling (FDM) were obtained by using a completely solvent-free process based on direct melt compounding and extrusion. The optimal CNT content in the filaments for FDM was found to be 6 wt %; for this composite, a detailed investigation of the thermal, mecha...
متن کاملElectrical resistance of CNT-PEEK composites under compression at different temperatures
Electrically conductive polymers reinforced with carbon nanotubes (CNTs) have generated a great deal of scientific and industrial interest in the last few years. Advanced thermoplastic composites made of three different weight percentages (8%, 9%, and 10%) of multiwalled CNTs and polyether ether ketone (PEEK) were prepared by shear mixing process. The temperature- and pressure-dependent electri...
متن کاملManufacture of Cnt Reinforced Polymer Composites Using Nanofibers Containing Cnt
Carbon nanotubes (CNTs), discovered by Japanese scientist Sumio Iijima, have outstanding material properties such as mechanical, thermal, electrical, and magnetic properties. For example, CNTs are not only lighter than common irons, but also 100 times stronger than the irons. However, CNTs are so tiny, that is, surface area per volume is relatively large. Consequently, they tend to agglomerate....
متن کاملTesting of Materials for Rapid Prototyping Fused Deposition Modelling Technology
Paper presents knowledge about types of test in area of materials properties of selected methods of rapid prototyping technologies. In today used rapid prototyping technologies for production of models and final parts are used materials in initial state as solid, liquid or powder material structure. In solid state are used various forms such as pellets, wire or laminates. Basic range materials ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Testing
سال: 2017
ISSN: 0142-9418
DOI: 10.1016/j.polymertesting.2017.08.024