Fungal Growth on Different Building Materials- Review
نویسندگان
چکیده
منابع مشابه
Associations between fungal species and water-damaged building materials.
Fungal growth in damp or water-damaged buildings worldwide is an increasing problem, which has adverse effects on both the occupants and the buildings. Air sampling alone in moldy buildings does not reveal the full diversity of fungal species growing on building materials. One aim of this study was to estimate the qualitative and quantitative diversity of fungi growing on damp or water-damaged ...
متن کاملVolatile metabolites produced by two fungal species cultivated on building materials.
Two fungal species commonly found in indoor environments, Penicillium commune and Paecilomyces variotü, were cultivated on pine wood and on a combination of gypsum board and mineral wool. Air from the cultures was adsorbed on Tenax TA and analysed using thermal desorption-cold trap injection gas chromatography. Identification of the produced volatile metabolites was performed by mass spectromet...
متن کاملThe growth of Scenedesmus sp. attachment on different materials surface
BACKGROUND Microalgae has been concerned as a potential source of biodiesel in the recent years. However, it is costly to harvest microalgae as it is commonly cultured in water and the cells are too small to harvest. In order to reduce the cost of cultivation and harvesting, it is important to improve the biomass productivity of microalgae. Here, we utilized the attachment method to culture mic...
متن کاملEstimating radiation dose from building materials
Background: Natural radioactivity in materials under certain conditions can reach the hazardous radiological levels. So, it becomes necessary to study the natural radioactivity in different materials to assess the dose for the population in order to know the health risks and to have a baseline for future changes in the environmental radioactivity due to human activities. Materials and ...
متن کاملA Review on Optimization of Machining Parameters for Different Materials
For the new products, it is necessary to acquire new technologies to produce and process them. Mostly the product quality depends upon on the surface roughness, fatigue life improvement, corrosion resistance, aesthetics, precision fit of mating surfaces etc., because this affects on product quality. This paper provides literature review on machining parameters, such as cutting speed (Vc), feed ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2018
ISSN: 2321-9653
DOI: 10.22214/ijraset.2018.4188