Fundamental Analysis of Plunge Grinding Process (3rd Report)
نویسندگان
چکیده
منابع مشابه
Realisation of grinding-hardening in workpieces of curved surfaces—Part 1 Plunge cylindrical grinding
This paper investigates the feasibility to achieve grinding-hardening in a plunge cylindrical grinding process. To understand the mechanisms, a temperature-dependent finite element heat transfer model incorporating a triangular moving heat source was developed to describe the temperature field, thus to predict the thickness of the grinding-hardened layer. The analysis carried out included the v...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملProcess Analysis and Design for Grinding Robot Tool Holders
A simple and effective solution to the robot grinding problem is introduced, which significantly reduces vibrations during grinding without additional actuators or active control. The objective is to determine the optimal compliance design for grinding robot tool holders. Specifically, the tool holder design should improve accuracy and productivity while protecting the robot arm from the large ...
متن کاملModeling of the Process of Coal Grinding
T. Wyleciał, H. Radomiak, D. Urbaniak, Częstochowa University of Technology, Czestochowa, Poland The use of coal in the steel industry, similarly as in the whole national ec onomy, is often preceded by its pre-treatment. Coal is mined in the form of big solids, but, being in such a form, it can’t be combusted, sintered, or gasifi ed. Therefore, it needs t o be appropriately grinding. In the pap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1976
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.42.686