FULL ANNEALING OF LOW ALLOY STEEL THICK FORGINGS BY A ISOTHERMAL TRANSFORMATION. (I)
نویسندگان
چکیده
منابع مشابه
Low–Alloy Duplex, Directly–Quenched Transformation–Induced Plasticity Steel
A duplex microstructure consisting of allotriomorphic ferrite and austenite at ambient temperature, has been produced in a low–alloy steel, by a simple heat treatment which involves intercritical annealing followed by quenching. The tensile properties obtained are good, with a total elongation of some 28% at an ultimate tensile strength approaching 900MPa. The form of the stress versus strain c...
متن کاملLow Carbon Steel Sheets Obtained by Reactive Annealing
This paper deals with the possibility of reducing carbon content by heat treatment in reactive atmospheres in order to improve plastic deformations properties of steel sheets. The heat treatment involves a decarburation annealing after a cold rolling, as opposed to the traditional process that performs the heat treatment in non-reactive atmospheres. Some of the most relevant variables were stud...
متن کاملExperimental Studies on the Microstructure and Hardness of Laser Transformation Hardening of Low Alloy Steel
An experimental investigation with Nd:YAG laser system was carried out to study the effects of laser hardening process parameters on the microstructure and hardness during laser hardening of EN25 steel. The laser beam is allowed to scan on the surface of the work piece by varying the laser beam power (750–1250 W) and travel speed (500–1000 mm/min) of the work table. The microstructural features...
متن کاملThe effect of quenching media and annealing temperature on graphitization transformation kinetic of CK100 tool steel
In this research, graphitization transformation of a commercial hypereutectoid steel called CK100 was studied by the dilatometric experiments at the range of 600 – 700 °C from prior martensitic structure. Also the effect of quenching media on the initial graphitization time and completion of transformation has been discussed. Also, graphitization transition from the different prior microstructu...
متن کاملCavitation Damages Morphology of High-strength Low-alloy Steel
V. Aleksić, Institute for Testing Materials-IMS Institute , Belgrade, Serbia, M. Dojčinović, Lj. Milović, University of Belgrade, Faculty of Technology and Metallurgy, Belgrade, Serbia, I. Samardžić, University of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Croatia. This paper presents the research into behaviour of HSLA steel affected by cavitation. The parent material (PM) and s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1949
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.35.10_355