Froth density profiles and froth height on perforated plate.
نویسندگان
چکیده
منابع مشابه
Pumping Oil Sand Froth
Froth is the basis to the extraction of bitumen from oil sand. Its components include sand, bitumen, water, and air. The technology of extraction and processing is evolving toward lower temperature of operation where the volumetric content of air and viscosity of bitumen challenge pumping. To improve the efficiency of froth handling pumps it is important to adapt the technology from other indus...
متن کاملSoap and the Interstellar Froth
We investigate, whether the alleged failure of standard photoion-ization codes of the Diffuse Ionized Gas (DIG) is simply caused by geometrical effects and the insufficient treatment of the radiative transfer. Standard pho-toionization models are applicable only to homogeneous and spherical symmetric nebulae with central ionizing stars, whereas the geometry of disk galaxies requires a 3D distri...
متن کاملFroth flotation of phosphate rock
The development of froth flotation is traced from its earliest-known use through the discoveries leading to the present knowledge of the science. The factors influencing the flotation of non-sulfide and non-metallic minerals are discussed, and the machines used in commercial flotation operations are described. Experimental work on the flotation beneficiation of phosphate rock is presented as an...
متن کاملOn-line Colour Measurement of Flotation Froth
This paper reports new results regarding the usefulness of colour measurements in flotation process. Colour measurements coming simultaneously from RGB-camera and a spectrophotometer (and from the same measurement point) are compared. The measured variables are used to construct a partial least squares (PLS) model and a multilinear regression (MLR) model for the prediction of the zinc content i...
متن کاملEstimation of Air Fraction Profiles in the Stabilized Froth and Froth Regions of a Flotation Column Using Conductivity Probes
In the collection zone of a flotation column, the air holdup is known to be relatively constant along the column height. The effect of the decrease in hydrostatic pressure with height may need to be taken into consideration, particularly for tall industrial columns. However, this phenomenon is readily ascertained. On the other hand, the changes at the pulp-froth interface, as well as the air fr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
سال: 1976
ISSN: 0021-9592,1881-1299
DOI: 10.1252/jcej.9.92